Propex Heatsource HS2000 Installation & Operation Instructions

the main cover must only be performed by an approved fitter or the manufacturer.

The heater should not be left for long periods without use. It is advisable to run the unit for

short periods throughout the summer.

The exhaust and inlet pipes should be inspected periodically for damage and any build-up

of dirt around the ends. Clean or replace as necessary.

The heater, its gas supply, and flues for the products of combustion are to be inspected in

accordance with national regulations or if these do not exist, the manufacturer's

recommendations, however, it is advised that this should be done at least annually.

The lockout must be cleared by turning the 'Fan Only' setting on the control panel, 'on', 'off'

and 'on' again within 2.5 seconds. If the first lockout reset attempt is unsuccessful, you can

retry an additional 4 times. If the lockout still will not clear (identified by a solid LED), please

turn off the heater, check the heater for faults, power up the heater and then further lockout

reset attempts can be made.

Manufactured By: Munster Simms Engineering

Distributed by; PROPEX HEATING & LEISURE LTD

Unit 10, Carvers Industrial Estate,

Ringwood, Hampshire. BH24 1JS

Tel: +44 (0)333 0110 488

Website: www.propexheatsource.co.uk

Email: info@propexheatsource.co.uk

180.121_0418

Installation

Operation Instructions

From April 2018

E N G I N E E R E D

C O M F O R T

R E L I A B I L I T Y

Page 1 Installation & Operation Instructions From April 2018 Manufactured By: Munster Simms Engineering Distributed by; PROPEX HEATING & LEISURE LTD Unit 10, Carvers Industrial Estate, Ringwood, Hampshire. BH24 1JS 180.121_0418 E N G I N E E R E D E N G I N E E R E D.
Page 2 SAFETY WARNINGS & GENERAL INFORMATION FAULT FINDING The Heatsource HS2000 is intended for use only as a space heater in caravans, motor The Heatsource HS2000 is equipped with an electronic diagnostic system which will detect caravans, mobile homes/units. fault conditions ranging from poor gas or electricity supply to internal heater malfunctions. In.
Page 3 A “P” clip is provided for fixing the end of the pipe to the underside of the vehicle with The Heatsource HS2000 heater is supplied with 2 wiring looms, a 2 core (red the end cap slightly protruding under the sill or bumper and pointing towards the rear and black) and a 6 core, both are fitted with terminals and housings to plug into of the vehicle.
Page 4 Find a suitable location which allows access to the heater with suitable room for service fan will blow cold air continuously. and inspection, usually in a bed-box or locker. The Heatsource HS2000 should be fitted in an area allowing a minimum distance of 25mm from adjacent walls, ceiling or Sequence of operation: shelves from the main body of the heater.